Steak Recipe - How To Make Steak Tender You invest a lot of time and money into the steaks for a special occasion and when dinner time comes, they are tough. What happened? How can you cook steaks as tender as your favorite restaurant? The first step to cooking a good steak is to choose the right grade of steak. The top quality beef is graded USDA Prime and commands top prices. USDA Prime grade meats are sold to the restaurant industry and specialty markets and are not as likely to be found at your local grocery chain. The next grade of beef is USDA Choice. USDA Choice is tender, flavorful and only slightly lower in quality than USDA Prime. The meat is well marbled with fat and will be tender and juicy when properly prepared. USDA Choice makes up about 70% of all graded beef and is readily available in your supermarket. USDA Good graded beef is an acceptable grade of beef that has only minimal marbling of fat. It is leaner, but may not be as tender as USDA Prime or Choice. Next, ...
When to Use High Heat on Your Barbeque
While some people really seem to have a knack for barbequing always grilling up a perfect meal for the rest of us, it is something that must be learned, not something that just comes naturally. Believe it or not, there is technique involved. Its not just a matter of following your cooking instincts.
One of the main secrets of knowing exactly how to make a beautiful, tasty meal every time is knowing how and when to use high heat or very hot coals.
Though you may have heard the term “seal in the juices” when it came to barbequing, you may even have tried some techniques every now and then, but unless youre doing it properly, you wont be getting it right. For the best results, many barbeque chefs cook vegetables and medium-rare steaks by first using a high heat in order to sear the outside of the food and seal both the juices and the flavors inside.
Though this technique is good for foods that you dont want to cook thoroughly, it shouldnt be overused. If youre cooking a meat such as hamburgers or pork ribs, they must be cooked all the way through in order to avoid bacterial contamination. Therefore, searing them to seal in the juices doesnt do anything but give you dry, or charred food.
This can be explained by understanding the way that meat cooks on a barbeque. As it is heated, the cells and the fibers of the meat will tighten, squeezing out much of the juices. Therefore, if youre only cooking a meat partially, searing it will help to seal in the juices by quickly cooking the outer layers of the food. However, if you should leave the food on this high heat, the inner layers will cook too quickly, vaporizing all of your precious and tasty juices. Try the technique a few times until you get it right. Pay attention to what youre doing, so that when you do accomplish the right technique, you know how to repeat it.
When you are using high heat, the rule of thumb is to cook on each side for a maximum of five minutes (a total of ten minutes). After ten minutes, anything that youre cooking should be moved aside to a medium heat so that it can finish cooking at that lower temperature.
There are many ways to recognize how hot your fire really is, to make sure that its always perfect for any kind of food that youre cooking on your barbeque. One of the most common tests is simply to hold your hand a couple of inches away from the grill. If youre only able to keep it there for about a second, your grill is at a high heat (that is, over 600F). If youre able to hold your hand there fore a few seconds, its at a medium heat (around 400F). At a lower heat, youll be able to hold your hand there for over five seconds.
Remember, when it comes to high heat, practice makes perfect, and the perfect is well worth the practice!
Comments
Post a Comment